Quantity: 100 pieces per box.

This is the same great igniter as our original Falcon igniter, but with an improved straight-on clamp design instead of sideways. This new design is easier to use and improves reliability.

Now you can ignite your fireworks like the pros. With our new Falcon Electic Igniters and your favorite firing system, you can put on a dramatic fireworks display just like the pros - at a fraction of the cost. Now there is no reason to make your own igniters out of expensive, messy kits. These are ready to go, right out of the bag. Check out our video (below) for a demonstration.

* No license needed to purchase this kind of electrical igniter.
* No shipping restrictions or hazmat fees like with regular electic igniters.
* Very reliable ignition source for all of your favorite fireworks. Lights visco reliably when you follow our video instructions.
* Safer than lighting by hand!
* Recommended firing current: 6V - 12V
* Maximum no-fire current: 5mA

NOTE: These igniters work best with firing voltage in the 6V - 12V range. If you are using a capacitive discharge firing system or a higher voltage firing system it may cause the igniter wire to heat-up and burn out so quickly (a fraction of a second) that it doesn't have time to actually ignite the visco fuse. Try nipping the fuse halfway through its thickness and attach the igniter at that point. Then try firing the igniter. This usually solves any ignition problems as nipping the fuse exposes the inner core of the visco and allows easier lighting.

• Resistance: 2.5± 1 Ohm
• All fire rating: 12±3v @ >1A
• Maximum safety fuse diameter: = 3 mm
• Shelf life: 3-5 years